KRONE operation terminal Gamma
77
Pos: 26.1 /Überschri ften/Überschri ften 1/K-O/KRONE Bedienter minal Gamma @ 47\mod_12852 22236593_78.doc @ 455915
8 KRONE operation terminal Gamma
Pos: 26.2 /BA/Sic herheit/Gefahrenhin weise/Bedieneinheit sc hützen @ 0\mod_12003082 47867_78.doc @ 39598
Caution! - Protect Control Unit.
Effect: Damage to the control unit
• The control unit must be protected against water.
• If the machine is not used for an extended period of time (for example during the winter),
the control unit must be stored in a dry place.
• For mounting and repair jobs, especially for welding jobs on the machine, disconnect the
power supply to the control unit. Overvoltage can damage the control unit.
Pos: 26.3.1 /BA/I nfo-Center/Großpackenpr esse/Anbau/Allg emeine Beschreibung @ 17\ mod_1236670842523_7 8.doc @ 205896
Fig. 36
The electronic equipment of the machine consists essentially of the job computer (1), the control
unit (3) and the control and function elements.
The job computer (1) is located on the front left of the machine under the side hood.
Its functions are:
• Regulation of the baling density
• Bale counter
• Control of the actuators installed on the machine
• Transfer of alarm messages
• Sensor/actuator diagnostics
The control unit (3) communicates information to the driver and performs settings to operate the
machine. This information is received and further processed by the job computer.
Pos: 26.3.2 /BA/- ----Seitenumbruch- ----- @ 0\mod_119617531122 6_0.doc @ 4165
To Next Page
Loading...
