Operation
205
Pos: 34.15.20 /BA/Ei nstellungen/Schnei dwerk/Verstopfung en entfernen Big Pack @ 20\ mod_1238654439288_78. doc @ 224033
11.6 Removing blockages
• Wait until all moving components stop
• Apply the flywheel brake
• Lower the cutting system with the tractor hydraulics (with the Comfort electronics system:
Activate the tractor hydraulics and hold down “Lower blade bar” on the control unit display
or on the machine buttons until the cutting system is lowered all the way down)
CAUTION! - Sharp parts
Effect: severe risk of injury
Always wear protective gloves when removing blockages.
Note
Due to too low ground clearance, the cutting system must immediately be lifted after removal of
the blockage, otherwise the cutting system inlet tray will be damaged. Should the cutting
system inlet tray be extremely dirty, clean it before lifting.
• Remove blockage
• Raise the cutting system with the tractor hydraulics (with the comfort electronics system:
Activate the tractor hydraulics and hold down “Lift blade bar” on the control unit display or
on the machine buttons until the cutting system is lifted all the way).
Pos: 34.16 /BA/-----Seitenumbruch------ @ 0\mod_1196175311226_ 0.doc @ 4165
To Next Page
Loading...
