Krone Big Pack 890 - Setting the Bale Length (Only with Electr. Bale Length Setting)

KRONE operation terminal Gamma
90
Pos: 26.8.22 /BA/I nfo-Center/Großpacken presse/Grundbild Handbetrieb/Einst ellen der Ballenlänge Handbetrieb Bild @ 18\mod_123 7450728927_78.doc @ 210271
Fig. 46
Pos: 26.8.23 /BA/I nfo-Center/Großpacken presse/Grundbild Handbetrieb/Einst ellen der Ballenlänge Handbetrieb @ 18\mod_1237 451044396_78.doc @ 21029 6
8.5.4 Setting the bale length (only with electr. bale length setting)
Note
(BP 890;1270;1290)
The bale length can be set in the range from 100 - 270 cm (39 - 106 inches).
(BP 1290 HDP; BP 12130)
The bale length can be set in the range from 100 - 320 cm (39 - 126 inches).
Note
Adjust the bale length should only at the start of a bale. Otherwise there could be a transitional
length.
• Press the rotary potentiometer until the symbol is in front of the target bale length (A)
• Turn the rotary potentiometer to set the desired bale length
• Press the rotary potentiometer until the symbol
is in parking position (B)
Note
By pressing the rotary potentiometer (for about 3 sec.) out of the parking position (B) the bale
length will be set to zero.
Pos: 26.8.24 /BA/-----Seitenumbruch------ @ 0\mod_1196175311226_0.doc @ 4165