Krone Big Pack 890 - Menu 1-6-2 Bales; Blow

KRONE ISOBUS-Terminal CCI 100
166
Pos: 28.69 /BA/Inf o-Center/CC-ISOBUS- Terminal/CCI-Bi G Pack/Hauptmenüs/Haupt menü 1 Einstellungen/ Menü 1-6-2 „Ballen / Blasen“ @ 44\mod_1275378983265_7 8.doc @ 391257
9.9.5.2 Menu 1-6-2 „Bales / blow“
CC000060
1-6-2
1..n
CC000034
1-6-2
1..n
Fig. 110
(On machines with electronic knotter triggering)
Dust and accumulated crop material is removed from the knotters by compressed air at regular
intervals (depending on the number of bales produced). Settings from 0.5 to 3 bales are
possible. If you select a setting of 0.5, half of the bale is blown out at the end of the bale.
Adjusting the number of bales
Calling the menu
Main menu 1-6 "Knotter blowing" appears.
• You can select menu 1-6-2
1..n
by pressing function key or . The symbol is shown
in reverse colors
• Press function key
The display shows menu 1-6-2 "Bales / blow".
The bar display and value (A) indicate the preselected number of bales.
The symbol
in the upper line indicates that the displayed value is saved.
• Set the desired number of bales with function key
or . The symbol in the top line
disappears
• Press the function key
. The set value is saved and the symbol in the upper line
appears
• By pressing the function key
the value of the factory setting appears (press function
key
, the value of the factory setting will be saved, the symbol appears in the
upper line)
• Pressing the function key
closes the called up menu
• Pressing the function key
and holding it down brings up the basic screen
Pos: 28.70 /BA/-----Seitenumbruch------ @ 0\mod_1196175311226_ 0.doc @ 4165