Settings
251
Pos: 38.105.9 /BA/Ei nstellungen/Großpac kenpresse/Pressko lbeneinstellung/La ufschienenreini gung @ 24\mod_12414233477 74_78.doc @ 243762
12.9.2 Cleaning the running rails
Fig. 185
The cleaning rails (2) are positioned on the four rollers (3). They remove dirt deposits from the
running rails of the baling ram. To adjust, loosen the screws (1) and adjust the cleaning rails to
the dimension a = 1 - 2 mm. Tighten the screws again.
Note
The cleaning rails (2) must be able to tilt easily on the roller axis!
Pos: 38.105.10 /BA/Ei nstellungen/Großpac kenpresse/Pressko lbeneinstellun g/Seitliche Einste llung des Kolbens @ 24\mod_124 1423485915_78. doc @ 243786
12.9.3 Lateral setting of the plunger
Fig. 186
The baling ram must be aligned in the centre of the bale channel chamber.
Make sure that the plunger moves freely and does not scrub against the fixed scrapers in the
bottom of the channel and below the knotter mechanism.
To align the plunger laterally, the plunger (2) can be moved to its forward-most position by
turning the flywheel.
The plunger (2) can be aligned laterally with compensating plates (1) (283-676-0) that are
mounted between the plunger (2) and the sliding discs (3). The plunger should have a gap
dimension of a = 1 - 2 mm at the narrowest point of the bale channel chamber.
Pos: 38.105.11 /BA/- ----Seitenumbruc h------ @ 0\mod_119617531 1226_0.doc @ 4165
To Next Page
Loading...
