Krone Big Pack 890 - PTO Shaft; Length Adjustment

Commissioning
57
Pos: 18.15 /Überschri ften/Überschri ften 2/F-J/Gelenkwell e @ 0\mod_1199781879794_7 8.doc @ 34542
5.4 PTO shaft
Pos: 18.16 /Überschri ften/Überschri ften 3/K-O/Längenanpas sung @ 1\mod_12016876328 10_78.doc @ 53589
5.4.1 Length adjustment
Pos: 18.17 /BA/Sic herheit/Gelenkwelle/S ich drehende Gelenk welle_3 @ 17\mod_12362580 86816_78.doc @ 204184
DANGER! - Rotating universal shaft!
Effect: Danger to life or serious injuries
• Before pushing the universal shaft onto the P.T.O. shaft of the tractor, disengage the
P.T.O. shaft, turn off the engine and pull out the ignition key. Apply the flywheel brake
• Secure the tractor and machine against unintentional rolling
• In the cornering movements required for adapting the length of the universal shaft no one
may stand between the machine and the tractor
Pos: 18.18 /BA/Er stinbetriebnahme/Großpac kenpressen/Anpa ssen Gelenkwelle Bild @ 33\ mod_1253784700411_78. doc @ 317266
Fig. 17
Pos: 18.19 /BA/Er stinbetriebnahme/Großpac kenpressen/Anpa ssen Gelenkwelle kürze ste Stellung @ 17\mod_1236 257834378_78.doc @ 204156
To adapt the length of the universal shaft, hitch the machine onto the tractor. The shortest
position of the universal shaft is reached in close cornering.
Pos: 18.20 /BA/Er stinbetriebnahme/Easy Cut/Längenanpassun g_ohne Pfahlsicher ung @ 10\mod_1221813873039_ 78.doc @ 138060
The length of the PTO shaft (1) must be adjusted.
• Disassemble the PTO shaft.
• Install each half (1) and (2) on the tractor and machine side respectively.
• Check the special section tubes and guard tubes.
• Shorten special section tubes and guard tubes to an extent that the PTO shaft can move
freely in the shortest operating position.
• For additional operating instructions refer to the operating instructions of the PTO shaft
manufacturer.
Pos: 19 /BA/-----Seitenumbruch------ @ 0\mod_1196 175311226_0.doc @ 4165