Krone Big Pack 890 - Menu 1-6-2 Bales; Blow

KRONE operation terminal Gamma
110
Pos: 26.30.24 /BA/I nfo-Center/Großpacke npresse/Hauptmenü s/Hauptmenü 1 Einstel lungen/Menü 1-6-2 „Bal len / Blasen“ @ 18\mod_1237 986586600_78.doc @ 212040
8.11.6.2 Menu 1-6-2 „Bales / blow“
BPK40652
A
BPK40653
Fig. 63
(On machines with electronic knotter triggering)
Dust and accumulated crop material is removed from the knotters by compressed air at regular
intervals (depending on the number of bales produced). Settings from 0.5 to 3 bales are
possible. If you select a setting of 0.5, half of the bale is blown out at the end of the bale.
Adjusting the number of bales
Calling the menu
Main menu 1-6 "Knotter blowing" appears.
• You can select menu 1-6-2
1..n
with the rotary potentiometer. The symbol is shown in
reverse colours
• Press the rotary potentiometer
The display shows menu 1-6-2 "Bales / blow".
The bar display and value (A) indicate the preselected number of bales.
The symbol
in the upper line indicates that the displayed value is saved.
• Press key
for softkey DEF: the factory setting value is accepted. The symbol in
the upper line may go out
• Set the desired number of bales with the rotary potentiometer. The symbol
in the top
line disappears
• Press the rotary potentiometer. The set contrast value is saved and the symbol
appears in the upper line
• You can use the key
to close the menu currently displayed
The display shows menu level 1-6 "Knotter blowing".
• Pressing the key
repeatedly brings up the basic screen
Pos: 26.30.25 /BA/- ----Seitenumbruch------ @ 0\mod_1196175311226_0.doc @ 4165