Maintenance
267
Pos: 42.10 /Überschri ften/Überschri ften 2/A-E/Anheben @ 33\mod_1 254380091415_78.doc @ 319041
13.3 Lifting
Pos: 42.11 /BA/W artung/Großpackenpressen/ Anheben der Maschine (201 0-12-20 13:07:58) @ 32\mod_1253095983436_ 78.doc @ 311721
13.3.1 Lifting eyes
The baler is equipped with four suspension points:
• Two suspension points are located in the front area of the drawbar (1) (right and left side
of the machine)
• Two suspension points are located in the rear area of the yoke (2) (right and left side of
the machine)
13.3.2 Lifting
• Use a lifting traverse with a minimum load-bearing capacity (depending on the gross
vehicle weight of the machine) (refer to chapter Introduction “Identification”)
• Apply the flywheel brake
• Swivel the parking support (parking jack) into transport position
• Fold in roller chute (bale chute)
• Lift the Pick-up
• Lock the coaster/steering axle (optional)
• Make sure, that all safety devices are locked
• Attach the chains of the lifting traverse on the four suspension points of the baler:
• Make sure, that the hooks of the chains are correctly attached to the suspension points
Pos: 42.12 /BA/-----Seitenumbruch------ @ 0\mod_1196175311226_ 0.doc @ 4165
To Next Page
Loading...
