Krone Big Pack 890 - Baling Ram Setting; Setting the Baling Ram Blades

Settings
250
Pos: 38.105.1 /Übersc hriften/Überschr iften 2/P-T/Preßkol beneinstellung @ 24\mod _1241419994977_78.doc @ 243592
12.9 Baling ram setting
Pos: 38.105.2 /BA/Ei nstellungen/Großpac kenpresse/Pressko lbeneinstellung/ Hinweis Preßkolbenein stellung @ 24\mod_124 1421462290_78.doc @ 243690
Note
• The Rollers of the baling ram must bear weight equally
• The gap between the baling ram blades and the blades in the baling channel must be the
same over the entire width of the plunger
Pos: 38.105.3 /BA/Ei nstellungen/Großpac kenpresse/Pressko lbeneinstellung/P reßkolbeneinstel lung Bild @ 24\mod_12414200 71196_78.doc @ 243642
Fig. 184
Pos: 38.105.4 /BA/Ei nstellungen/Großpac kenpresse/Pressko lbeneinstellung/ Anzahl der Gegenschnei de @ 24\mod_1241421588618 _78.doc @ 243714
The baling channel is equipped with two counterblades (6).
• The baling ram (3) of the BiG PACK 1270 / 1290 / 12130 is equipped with seven blades
(5)
• The baling ram (3) of the Big Pack 890 is only equipped with 5 blades (5) because of the
small width of the bale channel chamber
Pos: 38.105.5 /BA/Ei nstellungen/Großpac kenpresse/Pressko lbeneinstellung/E instellung der Pr eßkolbenmesser BP 890 / BP 1270 / BP 1290 @ 24\mod_1241422788196_ 78.doc @ 243738
12.9.1 Setting the baling ram blades
A precise setting of the baling ram blades is necessary for the underside of the big bales to
have a smooth surface.
BP 890 / BP 1270 / BP 1290
The height of the baling ram can be adjusted with the eccentric rollers (2) to adjust the distance
"a" = 2 to 4 mm.
After you have loosened the clamp bearings (1) the eccentric rollers are turned to raise and
lower the baling ram.
After the setting is made, the clamp bearing must be tightened again. Check that the guide rails
(4) and the rollers do not become soiled. This can result in increased wear and a height
adjustment for the baling ram that is not sufficiently precise.
Pos: 38.105.6 /Abkürzun gen /Abkürzungen spr achneutral/Großpac kenpresse/Big Pac k 1290 HDP @ 32\mod_12530895018 74_0.doc @ 309828
Big Pack 1290 HDP
Pos: 38.105.7 /BA/Ei nstellungen/Großpac kenpresse/Pressko lbeneinstellung/E instellung der Pr eßkolbenmesser BP 1290 HDP / BP 1213 0 @ 32\mod_1253088950827 _78.doc @ 308473
For setting the distance “a” = 2 to 4 mm, spacer washers can be placed under the blades (5).
Pos: 38.105.8 /BA/- ----Seitenumbruch------ @ 0\mod_1196175311226_0.doc @ 4165