Krone Big Pack 890 - Manual Mode; Manual Mode Basic Screen

KRONE ISOBUS-Terminal CCI 100
144
Pos: 28.28.1 /Überschr iften/Überschr iften 2/F-J/Handbetr ieb @ 43\mod_12750290136 25_78.doc @ 389186
9.3 Manual mode
Pos: 28.28.2 /BA/I nfo-Center/CC-I SOBUS-Terminal/CCI- BiG Pack/Grundbild Handbetri eb/Grundbild Handbe trieb @ 43\mod_1275029 627578_78.doc @ 389211
9.3.1 Manual mode basic screen
F1
F2
F3
F4
F5
F6
F7
F8
F9
F10
F11F11
F12
CC000019
Fig. 92
Pos: 28.28.3 /BA/I nfo-Center/CC-I SOBUS-Terminal/CCI- BiG Pack/Grundbild Handbetr ieb/Statuszeile ( I) oberste Zeile @ 43\mod_127 5032025046_78.doc @ 389236
Status line (I)
Current states of the machine (depending on how it is equipped) are shown in the top line of the
display:
Alarm message is pending
Bale ejector out
Bale channel flaps open (if the
P.T.O. shaft is turning the symbol is
flashing)
Bale ejector in
Bale channel flap closed
Max. machine utilization. Utilization if
continuously inverted. Flashing on
low utilization if not inverted when
baling => check the packer feed
sensor.
Bale chute top
Bale chute below
Upper blade bar or blades are
active: cutting in operation
Blade bar below or blades are
passive: no cutting operation
Setting down bales takes place
Pos: 28.28.4 /BA/-----Seitenumbruch------ @ 0\mod_1196175311226_0.doc @ 4165