Settings
242
Pos: 38.100 /BA/Einste llungen/Großpacken presse/Knoter/ Inbetriebnahme Knoter @ 24\mod_1241083585365_78. doc @ 242950
12.8.2 Start-up
The knotter has been set and tested by the manufacturer. It should work properly without
requiring any further settings. If there are problems with tying when it is placed in service for the
first time, the mechanisms should not be set immediately, since this is usually caused by errors
that are caused by paint, rust and bare spots. It is recommended to remove the rust protection
grease from the twine retainer and knotter before start-up.
Pos: 38.101.1 /Übersc hriften/Überschr iften 3/A-E/Einf achknoter @ 24\mod_124108 3809568_78.doc @ 242978
12.8.3 Single knotter
Pos: 38.101.2 /BA/Ei nstellungen/Großpac kenpresse/Knoter/ Einfachknoter Raspe/ Knüpferhaken Einf achknoter Raspe Bild @ 47\mod_1 285048585953_78.d oc @ 455461
12.8.4 Knotter hook (single knotter)
Fig. 174
Pos: 38.101.3 /BA/Ei nstellungen/Großpac kenpresse/Knoter/ Knüpferhaken Text Do ppelknoter / Einf achknoter Raspe @ 47\mod_128504 6930718_78.doc @ 455408
The knotter tongue (5) of the knotter hook (2) is tensioned by the leaf spring (3) on the closer
(1).
• If the clamping effect on the knotter tongue (5) is too big, the knot will be left
hanging in the knotter tongue. The twine strand will rip
• If the clamping effect is too low, either no knot or a loose knot will form. These
faults can be avoided by correcting the spring tension on the leaf spring (3)
To do this:
• Undo nut (4) on the leaf spring (3) by about 60° or remove
Note
The knotter tongue (5) needs a slight minimum tension, for this reason never undo completely.
Pos: 38.101.4 /BA/- ----Seitenumbruch------ @ 0\mod_1196175311226_0.doc @ 4165
To Next Page
Loading...
