KRONE operation terminal Gamma
133
Pos: 26.42.5 /BA/I nfo-Center/Großpacken presse/Hauptmenüs/ Alarmmeldungen/3) Alarmmeldungen Tabel le allgemein 10-28 @ 19\mod_ 1238507468946_78.doc @ 220306
No. Image Description Possible cause Remedy
10
Baling pressure
exceeded
Error on the pressure limitation
valve
The pressure sensor could be
defective
- Stop the P.T.O. shaft
- Check the pressure limiting valve
for blockage
11
P.T.O. shaft is
turning
P.T.O. shaft is turning upon entry
into sensor or actuator
diagnostics or during diagnostics
- Stop the P.T.O. shaft immediately
- Perform diagnostics with the
P.T.O. shaft stopped
12
Blade bar down Blade bar is down during baling
- Raise the blade bar
16
Pick-up
Pick-up or cutting system is not
turning Blockage
- Check mechanics
Clean it
17
Knotter motor
Knotter motor has not triggered
any knots or the knotter sensor is
not set correctly
Check the knotter motor electrical
system
Check the mechanical
components in the area of knotter
triggering
Adjust the knotter sensor correctly
18
MultiBale
It is not possible to set the 2
positions MultiBale or total bales
No compressed air present
Adjust the MultiBale sensor
correctly
Check the mechanics in the area
of the knotter triggering
Fault in MultiBale valve (valve
jammed, coil defective, etc.)
Check the electronics in the area
of the MultiBale interlock
19
Packer feed Packer feed sensor set incorrectly - Adjust the sensor correctly
20
Error – bale
ejector activation
Bale ejector has been activated,
even though the bale chute is still
up
- Lower the bale chute and then
activate the bale ejector
21
Measuring/calibra
ting
The measuring and calibrating
sensors are probably mixed up
- Exchange the plugs for the
measuring and calibrating sensors
28
Central lubrication
monitoring
No grease
Blockage
Pump not running
- Add grease
- Clean central lubrication
- Check electrical system and
pump
Pos: 26.42.6 /BA/-----Seitenumbruch------ @ 0\mod_1196175311226_0.doc @ 4165
To Next Page
