KRONE ISOBUS-Terminal CCI 100
152
Pos: 28.35 /BA/Inf o-Center/CC-ISOBUS- Terminal/CCI-Bi G Pack/Grundbild Automati kbetrieb/Einstel len des Soll-Presskr aft Bild @ 43\mod_12752979 44000_78.doc @ 390420
Fig. 99
Pos: 28.36 /BA/Inf o-Center/Großpackenpr esse/Grundbild Auto matikbetrieb/Au tomatikbetrieb Pr esskraft (in %) @ 18\mod_1237 464672365_78.doc @ 210754
Pressing force (in %)
The value under the bar display and the height of the bar (1) indicate the current target pressing
force as a percentage rate. The value above the bar display and the arrows in the bar display
(2) indicate the set target pressing force as a percentage rate.
Pos: 28.37 /BA/Inf o-Center/Großpackenpr esse/Grundbild Auto matikbetrieb/Ei nstellen der Soll-Pr esskraft @ 18\mod_1237464 881708_78.doc @ 210779
Setting the target pressing force
In Automatic mode, the pressure is automatically set based on the measured plunger force.
Note
The pressure display may deviate significantly in the display. The control system will not work
unless the packer is supplying forage to the plunger.
Pos: 28.38 /BA/-----Seitenumbruch------ @ 0\mod_1196175311226_ 0.doc @ 4165
To Next Page
Loading...
