Operation
203
Pos: 34.15.15 /BA/Ei nstellungen/Schnei dwerk/Schneidwerk abs enken @ 20\mod_123864867 8585_78.doc @ 224008
Lowering the cutting system:
Fig. 133
Note
Before lowering, the upper (1) and lower (2) blade control systems must be in position (I) for the
blades to be drawn actively from the channel.
• Lower the cutting system with the tractor hydraulics (with the Comfort electronics system:
Activate the tractor hydraulics and hold down “Lower blade bar” on the control unit display
or on the machine buttons until the cutting system is lowered all the way down).
• Remove the ignition key and turn off the electrical system on the control unit
• Apply the flywheel brake
• Secure the tractor and machine against rolling
CAUTION! - Spring pressure is acting upon the key
Effect: Risk of injury
When shifting the blade control system from position (II) to position (I), be careful of the spring
pressure of the blades taking effect on the auxiliary tool (4) (risk of injury!).
Releasing the single blade locking device
• Turn the upper (1) and the lower (2) blade control system with the auxiliary tool (4) so far
until the cams of the blade control system are placed from position (I) to position (II)
• Unlock the cutting system inlet tray by activating the locking lever (3) and remove it as far
as the stopper
Pos: 34.15.16 /BA/- ----Seitenumbruch------ @ 0\mod_1196175311226_0.doc @ 4165
To Next Page
Loading...
