346
A
Absorbing mechanism ...................................... 259
Activating the bale ejector ................................ 209
Activating the cutting system ............................ 203
Actuator test .............................................. 124, 179
Adjusting the drawbar height .............................. 54
Adjusting the height of the drive train ................. 55
Adjusting the hydraulic system ................... 65, 278
Adjusting the Sensors ....................................... 317
Affixing the Adhesive Safety and Information
Labels ............................................................. 45
Air filter for pneumatic cylinder (only MultiBale)294
Alarm message ................................................. 184
Alarm Message ................................................. 130
Alarm messages ............................................... 185
Assembling the feeler rocker ............................ 256
At the End of the Harvest Season .................... 320
Attaching the ISOBUS terminal ........................ 192
Automatic centralised lubrication system (optional)
...................................................................... 312
Automatic mode .......................................... 92, 151
Auxiliary-function (AUX).................................... 195
B
Bale chute in transport position (optional) .......... 70
Baling force regulation ...................................... 207
Baling ram setting ............................................. 251
Basic screen manual mode ................................ 84
Basic screen manual mode ................................ 86
Basic setting of the band brake (flywheel) ........ 260
Before the Start of the New Season ................. 321
Blade Changing ................................................ 203
Brake connections .............................................. 25
Bringing up a Menu Level ................................... 97
Buttons on the machine .............................. 94, 153
C
Checking and maintaining tyres ....................... 272
Checking the lighting system .............................. 71
Checking the setting of the upper needle ......... 234
Checking the twine bar after the setting .......... 237
Cleaning ........................................................... 271
Cleaning the running rails ................................ 252
Coaster/steering axle (optional) ......................... 73
Commissioning .................................................. 53
Compressed Air Connections for the Compressed
Air Brake ........................................................ 66
Compressed-air reservoir ................................ 290
Compressor ..................................................... 293
Connecting the hydraulic lines ........................... 62
Connecting the terminal with ISOBUS ............. 140
Connecting the terminal without ISOBUS ........ 141
Connection prerequisites on tractor ................... 25
Contact ............................................................... 14
Cutting length ................................................... 202
Cutting system ................................................. 201
Cutting system drive gear ................................ 287
D
Dangers in Case of Non-compliance with the
Safety Instructions ......................................... 35
Description of baling process ..................... 95, 154
Description of the k
eys ...................................... 81
Diagnostics – analogue sensors .............. 121, 176
Diagnostics – digital actuators ......................... 180
Diagnostics – digital actuators ......................... 125
Diagnostics – force sensors ..................... 122, 177
Diagnostics – Namur sensors .................. 119, 174
Diagnostics - power supply voltages ............... 123
Diagnostics analogue actuators ....................... 181
Diagnostics analogue actuators ....................... 126
Diagnostics for buttons ............................ 120, 175
Diagnostics power supply voltages .................. 178
Diagram hydraulic block .................................. 279
Differing functions to KRONE ISOBUS terminal
CCI ............................................................... 193
Double knotter .................. 224, 225, 239, 247, 328
Drives ............................................................... 215
Driving and Transport ........................................ 69
Driving with Pick-up in fixed position ............... 199
To Next Page
