ISOBUS operation
175
Pos: 24.7 /BA/In fo-Center/Iso-Be dienung/BigP ack/Abweichen deF unktionen zu m KRONE ISOBU S-Termina CC I@ 47\mod_ 1285223499328_ 78.doc @ 455 993 @ 2 @ 1
9.2 Differing functions to KRONE ISOBUS terminal CCI
Via the accessory unit, the ISO control unit will provide information and control functions to the
display of the ISO terminal. Operation with an ISO terminal is analogue to the KRONE ISOBUS
terminal CCI. Prior to start-up, refer to the operating instructions for the method of operation of
the KRONE ISOBUS terminal CCI.
A fundamental difference to the KRONE ISOBUS terminal CCI is the arrangement of the
softkeys, which are determined by the selected ISO terminal.
Only the functions that differ from the KRONE ISOBUS terminal CCI are described in the
following.
Pos: 24.8 /BA/In fo-Center/Iso-Be dienung/Sch wader/Abweichend eF unktionen CC I_Terminal Au tomatikzeit @ 5 6\mod_12949 96225046_78.d oc @ 539878 @ @ 1
Note
The adjustment of the Automatic Time which is set in the basic screen “Lifting the rotors” for
KRONE comfort control, is set on the ISO terminal with the selection key predetermined by the
ISO terminal (see operating instructions of the ISO terminal manufacturer).
Pos: 24.9 /BA/In fo-Center/Iso-Be dienung/Abweic hende Funktio nenCC I_Ter mMe nüpunkt 1-4 „K ontrast“ @ 48\ mod_1286276 672656_78.doc @ 460458 @ @ 1
Note
Menu item 1-4 "Contrast" of the KRONE control cannot be called up on the ISO terminal. A
setting is performed directly via the ISO terminal (if applicable) (refer to operating instructions of
the ISO terminal manufacturer).
If necessary, acoustic signals must be enabled from the terminal (refer to operating instructions
of the ISO terminal manufacturer).
Pos: 24.10 /BA/--- --Seitenumbruc h------ @ 0\mo d_119617531 1226_0.doc @ 41 65 @ @ 1
To Next Page
Loading...
Need help?
General
