EasyManua.ls Logo

Krone Swadro 2000 - Install the PTO Shaft

Krone Swadro 2000
262 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Start-up
190
Pos: 26.32 /Überschrif ten/Überschrif ten 2/F-J/G elenkwelle montier en @ 2\mod_ 12023983427 88_78.doc @ 59 253 @ 2 @ 1
10.7 Install the PTO shaft
Pos: 26.33 /BA/Sic herheit/Gelenkw elle/Sich dr ehende Gelenkwelle _2 @ 0\ mod_119978169295 0_78.doc @ 3 4523 @ @ 1
Danger! - Rotating PTO shaft
Effect: Danger to life or serious injuries
Install or detach the PTO shaft only with the engine switched off and the ignition key
removed.
Secure the tractor against rolling.
Make sure that the PTO shaft is coupled properly (the lock of the PTO shaft must have
snapped in).
Make sure that the protective devices are attached properly.
Never use a PTO shaft, the protective devices of which have not been attached.
Replace damaged protective devices immediately
Attach the safety chain of the PTO shaft so that the guard tube does not rotate
simultaneously with the PTO shaft.
Pos: 26.34 /BA/Sic herheit/Gelenkw elle/Antriebsdr ehzahl 540 beachten @ 3\mo d_12053165182 45_78.doc @ 73595 @ @ 1
Danger! - Observe drive speed
Effect: Danger to life or serious injuries
This machine is driven at a maximum PTO speed of 540 rpm.
Pos: 26.35 /BA/I nbetriebnahme/ Schwader/Anba uG elenkwelle/A nbau Gelenkwelle Schwader 2000@ 22\mod_ 1239710940245_ 78.doc @ 232 564 @ @ 1
4
SW2000007
3
3
2
1
5
Figure 132
Switch off the engine and remove the ignition key.
Install the PTO shaft (1) on the machine side (wide angle on machine side).
Rotate the PTO shaft support (2) upwards.
Then slide PTO shaft onto the PTO of the tractor. In doing this, ensure that the sliding pin
is securely engaged.
Secure the PTO shaft guard against turning with the retaining chain (3).
Pos: 26.36 /BA/I nbetriebnahme/ Schwader/Maschin e anheben SW 2000 @ 21\ mod_12391930 42846_78.doc @ 231705 @ @ 1
Lifting the Machine
Lift the machine slightly.
Rotate the parking support (4) back 90°. Lock it in that position with the tension bar (5).
Pos: 26.37 /BA/--- --Seitenumbruc h------ @ 0\mo d_119617531 1226_0.doc @ 41 65 @ @ 1

Table of Contents

Related product manuals