Safety
21
Pos: 11.16 /BA/Sic herheit/Hydrauli kanlage @ 2\ mod_12035036 91986_78.doc @6 6225 @ 2 @ 1
4.6 Hydraulic system
1 The hydraulic system is pressurised!
2 When connecting hydraulic cylinders and motors, make sure the hydraulic hoses are
connected as specified!
3 When connecting the hydraulic hoses to the tractor hydraulics, make sure that the
hydraulics of both the tractor and the implement have been depressurized!
4 In the case of hydraulic connections between tractor and machine, the coupling sleeves
and plugs should be marked to ensure a proper connection! If the connectors are
interchanged, the function will be reversed (e. g. raising/lowering) - Risk of accident!
5 When searching for leaks, use suitable aids to avoid the risk of injury!
6 Liquids escaping under high pressure (hydraulic oil) can penetrate the skin and cause
serious injury! Seek medical help immediately should injuries occur! Danger of infection!
7 Before working on the hydraulic system, depressurise the system and switch off the
engine!
Pos: 11.17 /Überschrif ten/Überschrif ten 2/P-T/R eifen @ 0\mod _1197357995667 _78.doc @ 18 075 @ 2 @ 1
4.7 Tyres
Pos: 11.18 /BA/Sic herheit/Reifen @ 0\mod_119 5646435716_78.d oc @ 1346 @ @ 1
1 When working on the tyres, make sure that the implement is safely lowered and secured
against rolling (wheel chocks).
2 Installing wheels and tyres requires adequate knowledge and suitable tools!
3 Repair work on the tyres and wheels should be done by specially trained personnel using
appropriate installation tools only!
4 Check tyre pressure regularly! Inflate the tyres to the recommended pressures!
5 Check the wheel nuts periodically! Missing wheel nuts can result in a wheel falling off and
the machine tipping over.
Pos: 11.19 /BA/Sic herheit/Wartung/ Wartung Swa dro @ 2\mod_ 12035040221 26_78.doc @ 66 245 @ 2 @ 1
4.8 Maintenance
1 Always make certain that the drive and the engine are switched off before doing any
repairs, maintenance or cleaning! - Remove the ignition key!
2 Regularly check that nuts and bolts are properly seated and tighten if necessary!
3 When performing maintenance work with the machine raised, always secure it with
suitable supporting elements!
4 Oils, greases and filters must be disposed of correctly!
5 Always disconnect the power supply before working on the electrical system!
6 If protective devices and guards are subject to wear, check them regularly and replace
them in good time!
7 When performing electrical welding work on the vehicle and mounted devices, turn power
supply off at main battery switch or disconnect generator cable and battery!
8 Replacement parts must at least comply with the technical requirements set by the
manufacturer of the implements! This is guaranteed by original KRONE spare parts!
Pos: 11.20 /BA/--- --Seitenumbruc h------ @ 0\mo d_119617531 1226_0.doc @ 41 65 @ @ 1
To Next Page
Loading...
Need help?
General
