Krone Swadro 2000 - Connecting the Electrical Controls

Start-up
187
Pos: 26.25 /Überschrif ten/Überschrif ten 2/A-E/A nschluß der ele ktrischen Bedien ung @ 2\mo d_1202396974288 _78.doc @ 591 95 @ 2 @ 1
10.4 Connecting the electrical controls
Pos: 26.26 /BA/I nbetriebnahme/ Schwader/Ansc hluss elektrisch eB edienung/Ans chluss elektrisc he Bedienung S W 2000 @ 36\mod_126078495 4108_78.doc @ 336768 @ @ 1
SW2000006_1
3
1
5
A
4
I
II
6
III
B
3
2
7
Fig. 129
The connection for the electrical controls is provided by the power supply cable (1).
Note
If necessary, the continuous power socket and support for the control unit must be previously
installed on the tractor (see the chapter on starting up "Power Supply").
To do this:
• Connect the power supply cable (2) to the continuous power socket on the tractor and to
the socket (7) (2-pin) on the machine
• Insert the plug of the power supply cable (1) in the appropriate socket (3) of the machine
• Connect the connecting cable (I) of the power supply cable (1) to the distributor (4)
• Connect the connecting cable (II) to the socket (5) of the control unit (A) and to the
distributor (4)
• Connect the connecting cable (III) to the socket (6) of the control unit (B) and to the
distributor (4)
• Position the cable so that it will not come in contact with the wheels
Pos: 26.27 /BA/I nbetriebnahme/ Schwader/Hin weis Sauberkeit der Stecker und Steckdosen @ 2\ mod_1202399 563131_78.doc @ 59273 @ @ 1
Note
Before inserting the plugs, make certain the plugs and sockets are clean and dry. Dirt and
moisture may result in short circuits!
Pos: 26.28 /BA/--- --Seitenumbruc h------ @ 0\mo d_119617531 1226_0.doc @ 41 65 @ @ 1