Control Unit – Auxiliary Control
99
Pos: 20.1 /Übersc hriften/Übersc hriften 1/A-E/Be dieneinheit - Zus taztbedienung @ 23\mod_124 0387195364_78.d oc @ 239205 @ 1 @ 1
7 Control Unit – Auxiliary Control
Pos: 20.2 /BA/Sich erheit/Gefahr enhinweise/Bedie neinheit schütz en @ 0\mod_ 1200308247867 _78.doc @ 395 98 @ @ 1
Caution! - Protect Control Unit.
Effect: Damage to the control unit
• The control unit must be protected against water.
• If the machine is not used for an extended period of time (for example during the winter),
the control unit must be stored in a dry place.
• For mounting and repair jobs, especially for welding jobs on the machine, disconnect the
power supply to the control unit. Overvoltage can damage the control unit.
Pos: 20.3.1 /BA/ Info-Center/Sc hwader/Bedie neinheit- Komfort/ SW 2000/Allge meine Beschreib ung @ 22\mod _123995449587 0_78.doc @ 2 35067 @ @ 1
1
SW2000024
Fig. 62
The electronic equipment of the machine consists essentially of the job computer (1), the control
units (3,4) and the control and function elements.
The job computer (1) is located at the rear left above the running gear on the main frame of the
machine under the guard.
The control unit (3) communicates information to the driver and performs settings to operate the
machine. This information is received and further processed by the job computer.
The control unit (4) performs settings to operate the machine. This information is received and
further processed by the job computer.
The control unit (4) is only possible in combination with the control unit (3). The control unit (3)
must be switched on so that power is supplied to the control unit (4)! Once the control unit (4)
has been activated, all functions that can be accessed from control unit (4) are blocked in
control unit (3).
Pos: 20.3.2 /BA/--- --Seitenumbruc h------ @ 0\ mod_1196175311 226_0.doc @ 4165 @ @ 1
To Next Page
Loading...
Need help?
General
