Commissioning
29
Pos: 14.1 /Übersc hriften/Übersc hriften 1/A-E/Ers tinbetriebnahm e @ 0\mod_11 96314201498_7 8.doc @ 5855 @ 1 @ 1
5 Commissioning
Pos: 14.2 /BA/Sich erheit/Gefahr enhinweise/Fehl erhafter Zusa mmenbau @ 1\ mod_1202224212 591_78.doc @ 5 8171 @ @ 1
Danger! - Incorrect assembly
Effect: Danger to life, serious injuries or serious damage to the machine.
• Only authorised service centres may assemble the machine.
• The machine must be assembled with special care.
• Always heed the applicable accident prevention regulations.
• Use only safe and sufficiently dimensioned lifting equipment and load-securing
equipment.
• The machine may be taken into operation only after all the safety devices have been
installed.
• If unauthorised modifications are made to the machine, the manufacturer is released
from liability for any resulting damage.
Pos: 14.3 /BA/Sich erheit/Gefahr enhinweise/Eins tellarbeiten g ezogene Maschin en@ 0\mod_1 199717011038_7 8.doc @ 3398 0@ @ 1
Danger! - Unexpected movements of the machine
Effect: Danger to life or serious injuries.
• Setting tasks must only be performed when the drive is switched off and the engine is at
a standstill!
• Switching off the engine
• Remove the ignition key.
• Secure the machine against the possibility of rolling back.
Pos: 14.4 /Übersc hriften/Übersc hriften 2/A-E/Ers tmontage @ 1\mod_12022262 61982_78.doc @ 5 8270 @ 2 @ 1
5.1 First installation
Pos: 14.5 /BA/Ersti nbetriebnah me/Schwader/S wadro 1010/Allge mein SW 101 0 @ 8\mod_12 18715346326_7 8.doc @ 107666 @ @ 1
Some parts of the machine are not in their final mounted position for transport. Installation tasks
that must be completed before the machine is used for the first time are listed below. Since
safety equipment must also be mounted in some cases, the machine must not be placed in
operation before these tasks have been completely performed!
Pos: 14.6 /BA/Ersti nbetriebnah me/Erstanbau allg emein @ 4\ mod_1210248215 397_78.doc @ 8 2218 @ @ 1
The following instructions describe how to mount (assemble) the machine for the first time.
Only authorised service centres may assemble the machine.
When assembling the machine, follow the specified order of the installation steps as they are
listed!
Caution!
The machine must be assembled with special care. Always heed the applicable accident
prevention regulations. Use only safe and sufficiently dimensioned lifting equipment and load-
securing equipment. The machine must not be placed in operation until all safety devices have
been installed. If unauthorised modifications are made to the machine, the manufacturer is
released from liability for any resulting damage.
Operation of the machine is described in the corresponding operating instructions.
Pos: 14.7 /BA/---- -Seitenumbruch--- --- @ 0\mod _1196175311 226_0.doc @ 416 5@ @ 1