Field Option Description
Network
solution
Displa
yed when Use RTK network is
checked in RTK Rover Settings, RTK net-
work page.
Network
type
FKP, VRS,
MAX, i-MAX
The type of reference network selected in
RTK Rover Settings. Refer to "RTK Rover
Settings,RTK network page".
Nearest If Network type: Nearest is selected in RTK
Rover Settings, a singlebase solution is cal-
culated and the number of base stations
equals 1.
RTK data
format
Display only Refer to "RTK Rover Settings,General page".
Number of
reference
stations in
solution
Display only
•
Fo
r single-baseline solutions, this num-
ber is always 1.
•
For VRS and i-MAX, this number is
always 1 since it is not possible to derive
the number of base stations contributing
to the VRS or i-MAX corrections from the
data format.
•
For network solutions, this information is
derived from the content of the data for-
mat. Only RTCM v3 and Leica 4G are
able to provide this number.
Mountpoint Display only The name of the correction data stream that
was selec
ted from the source table received
in the TCP/IP port. Available for network RTK
with Ntrip.
The information is available for all Ntrip con-
nections independent from the Network
type used. The information is derived from
the Connection Settings, either manually
defined or selected from the NTRIP Source
Table.
Point meas-
ured inside
network
Display only Available for network RTK with Ntrip and MAX
and data format RTCM v3 or Leica 4G.
User ID Display only Available for single baseline RTK, network
RTK with/without Ntrip.
Next step
Page
changes to the next page.
On this page, multiple elevations which have been stored with a staked point
can be edit
ed. Additional multiple elevations can be entered.
Refer to "Stake Results,Elevations page" for more information on multiple ele-
vations.
Point ID,
Elevations page
86 Job Menu - View & edit data
To Next Page