Chapter 5 Cues
Page 88 Rev. 1.30.03.07.r1
Real Time Event Example Procedure
Follow below to assign cue 101 to be automatically run at 7:00pm (19:00),
Monday through Friday evenings, as Event #1:
Procedure: Notes:
1. Press [SETUP] (More) (RT Clk) Enters Setup display and
opens Real Time Event
Sub-display
2. Use the arrow keys to move the cursor
to the "E# 1" field.
3. Press [5] to set Scheduler to "ON"
4. Use the arrow keys to move the cursor
to the "Time" field of Event 1 (E# 1)
5. Press [ENTER]
6. Press [190000] [ENTER] Use 24 hour clock format
(hhmmss)
7. Use the arrow keys to move the cursor
to the "Day of Week" field of Event 1
8. Press [ENTER] then press [1] to All days of week are selected
deselect Sunday and press [7] by default
to deselect Saturday. Press [ENTER]
9. Use the arrow keys to move the cursor
to the "Cue" field of Event # 1 (E# 1)
10. Press [101] Cue 101 assigned to Event # 1
Using Macros to Execute Cues
A cue can be automatically executed by pressing a macro key which has a
recorded cue load and go sequence programmed into it. This is a quick way
to playback recorded cues with a single key press. The cue macro can also
then be assigned to a submaster allowing cue playback from a sub.
See
Chapter 8 Macros
for more information on using macros.
To Next Page
Loading...
