Chapter 5 Cues
Page 62 Rev. 1.30.03.07.r1
Recording Cues with Follow
As mentioned earlier in this chapter, a follow time specifies how long the
console waits after the current cue starts before the next cue automatically
executes.
Follow times can be recorded up to 99:59 minutes. For example, to add a
follow time of 2.5 seconds to a previously recorded cue:
Press [CUE] [10] [FOLLOW] [2.5] [ENTER].
To enter a follow time in minutes, press the (Minute) soft-key after you
enter the value: Press [CUE] [1] [FOLLOW] [5] (Minute) [ENTER].
The assigned follow time can be viewed in the "Flw" field of the attributes
line of the Preview display or from the Cuesheet display.
Follow these steps to record cue 2 with a fade and follow time in Stage:
Procedure: Notes:
1. Press [STAGE]
2. Press [1] [and] [21] Selects channels to be
recorded
3. Press [AT] [95]
4. Press [RECORD CUE] [2]
5. Press [TIME] [5] Adds Fade time
6. Press [FOLLOW] [10] [ENTER] The cue following cue 2 will
start 10 seconds after cue 2
starts
You cannot run a follow cue if the fade time is manual; enter a time of
0 seconds if you want the next cue to immediately execute.
To Next Page
Loading...
