Chapter 5 Cues
Page 74 Rev. 1.30.03.07.r1
Assigning Effects to Cues
When an effect is assigned to a cue, the effect fades in during the up time
of the cue. The effect remains running until the next [GO] command is
executed, at which time the effect fades out during the down time of that
cue.
To assign an effect as a cue is being recorded:
Procedure: Notes:
1. Press [RECORD CUE] [#] [EFFECT] [#]
2. Press [ENTER]
To assign an effect to an existing cue:
Procedure: Notes:
1. Press [CUE] [#] [EFFECT] [#]
2. Press [ENTER]
When recording a cue while an effect is running, take out the effect on
stage with the playback fader or submaster before executing the
Record Cue command. The live Record Cue command records an
instantaneous stage picture and therefore will record channel levels
from the effect if the effect is left running.
You can also place cues into effects so when the effect is run it will start a
cue. Only the levels of the channels in the cue are used, not the cue
attributes. See
Chapter 7 Effects
for more information.
To Next Page
Loading...
