User Guide Chapter 8 Macros
Rev. 1.30.03.07.r1 Page 125
Macro Paging
A single macro page contains eight macros assigned to the eight macro
hard-keys labeled [M1] - [M8]. The number of macro pages available is
set from the Setup display. To change the number of pages, press
[SETUP] [9] [ENTER], enter the number of pages (up to 64) then press
[ENTER] again. For more information on the Setup display see
Chapter 12
System Settings
.
Increasing the number of macro pages will affect the remaining number
of cues, groups, effects and submaster pages. Only use what you need.
The current macro page number is shown on the macro soft-key (MP #)
while in the Stage, Playback, Preview or Cuesheet displays.
For example, to change the current macro page 1 to macro page 3 while in
the Stage or Playback displays:
Procedure: Notes:
1. Press [STAGE] or [PLAYBACK]
2. Press (MP 1) Command Line reads:
"Macro Page"
3. Press [3] [ENTER] Soft-key changes to (MP 3)
To change the current macro page 1 to macro page 3 while in the Cuesheet
or Preview displays:
Procedure: Notes:
1. Press [CUESHEET] or [PREVIEW]
2. Press (More) in Cuesheet or
press (More) twice in Preview Changes soft-key level
3. Press (MP 1) Command Line reads:
"Macro Page"
4. Press [3] [ENTER] Soft-key changes to (MP 3)
To Next Page
Loading...
