Chapter 7 Effects
Page 122 Rev. 1.30.03.07.r1
Assigning Effects to Cues
When an effect is assigned to a cue, the effect fades in during the up time
of the cue. The effect remains running until the next [GO] command is
executed, at which time the effect fades out during the down time of that
cue.
To assign an effect to a cue press [CUE] [#] [EFFECT] [#] [ENTER]
A [LOAD] fader [#] [GO] command fades out all running cue effects
immediately.
Please refer to
Chapter 5 Cues
for more information on working with cues.
Assigning Effects to Submasters
An effect assigned to a submaster may be activated anytime you move the
submaster fader up or press the sub bump button. An effect activated on a
submaster with the fader will run at the proportional level set by the sub
fader until the fader is taken to zero.
To assign an effect to a submaster press:
[RECORD SUB] [#] [EFFECT] [#] [ENTER]
Refer to
Chapter 4 Submasters
for more information on using submasters.
To Next Page
Loading...
