User Guide Chapter 6 Groups
Rev. 1.30.03.07.r1 Page
Using the Only Key with Groups
The Only key is very useful when working with Groups. It can be used to
select "only" a channel or selection of channels from within a group. This
selection could be used to record other groups, subs, or cues. For example,
to select channels from a group live from the Stage display:
Procedure: Notes:
1. Press [STAGE]
2. Press [GROUP] [20] Group 20 has channels 1 - 24
already recorded
3. Press [ONLY]
4. [5] [THRU] [10]
5. [FULL] or enter a level Only channels 5 - 10
using [AT] [#] appear on screen
By using Only you can also select certain devices from a group of devices.
For example, if group 5 contained pan and tilt trait levels for devices 1
through 8 you could select only the pan and tilt trait levels for device 3 and
record them into another group:
Procedure: Notes:
1. Press [DEVICE] display key Opens Device display
2. Press [GROUP] [5]
3. Press [ONLY] [DEVICE] [3] Use Device key on
[ENTER] keypad
4. Use Trackball to place cursor Trait captured for record
over device 3 trait name and when white
press [SELECT] to highlight
5. Press [RECORD GROUP] [6]
6. Press [ENTER] Only device 3 pan and
tilt positions are
recorded to group 6
Alternatively in step 4, you could press [DEVICE] [3] [ENTER] and adjust
the pan and tilt traits by using the trackball or encoder wheels.
To release traits so that they will not be recorded, press (RelAll). See
Chapter 10 Automated Devices
for more information on working with
devices.
To Next Page
Loading...
