User Guide Chapter 9 Patching
Rev. 1.30.03.07.r1 Page 135
Chapter 9 Patching
Before you begin patching, you should set the of number of channels and
dimmers that you will be using. Please see
Chapter 12 System Settings
for
more information. By using only the amount of channels and dimmers
needed, you will speed up processing and allow for the greatest number of
cues, macros, effects, etc.
The console is shipped with Ports A and B configured as a 1 to 1 patch for
conventional channels and dimmers. Port C is configured for Automated
Devices. Although you can reconfigure your console as needed, it is
recommended to start with the factory configuration until you become
further acquainted with the console.
This chapter will cover the following topics:
• Patch Display
• Patch Parameters
• Navigating the Patch Display
• Patching 1 To 1
• Custom patching Channels to Dimmers
• Proportional Levels
• Patching Automated Devices
• Dimmer Check
• Profiles
• Navigating the Profile Sub-Display
• Creating and Assigning Custom Profiles
To Next Page
Loading...
