User Guide Chapter 3 Setting Channel Levels
Rev. 1.30.03.07.r1 Page 39
Restoring channel levels (“Undo”)
You can use the (Restor) soft-key to return channel levels to their level
prior to the last level setting command. The (Restor) soft-key is available
in the Stage, Preview, and Tracksheet displays. Although the previous level
command may not be present in the command line history, it remains
available to the restore command. For example:
Procedure: Notes:
1. Press [STAGE]
2. Press [1] [THRU] [20] [AT] [50] Levels set to 50%
3. Press [1] [THRU] [20] [AT] [90] Levels set to 90%
4. Press (Restor) [ENTER] Levels restored to 50%
Channels may also be selectively restored by entering a list of channels
which are to return to their previous level.
Channel Check Mode
Channel Check mode can be used to see which channel controls which light.
It is a quick method to sequentially verify individual channels. You may
start a channel check with any channel. The channel check soft-key is
accessed from the Stage display.
Follow these example steps to run a channel check:
Procedure: Notes:
1. Press [STAGE]
2. Press the (More) soft-key
3. Press the (ChnChk) soft-key
4. Press [1] [AT] [FULL] Captures the starting channel.
Specify any desired check
level.
5. Use the left/right arrow keys Level will show in boxed red
to scroll through channels video
6. Press [CLEAR] to stop check
To Next Page
Loading...
