Chapter 14 Alternate Control Interfaces
Page 210 Rev. 1.30.03.07.r1
Standard MIDI
The Standard MIDI Commands that the console can transmit/receive
include: Note On, Note Off, Control Change, Program Change and System
Exclusive (SysEx) messages. See table on next page. These commands all
use MIDI channels which allow a MIDI controller to send commands to
MIDI receivers. There are 16 MIDI channels (0-15) available when using
Standard MIDI. To select the channel that you would like your console to
transmit/receive on, you must first select Standard MIDI, then set the
channel desired. Follow the procedure below as an example:
Procedure: Notes:
1. Press [SETUP] Opens the Setup display
2. Press [18] [ENTER] Selects menu item 18:
“MIDI Transmit Mode”
3. Use the up/down arrow keys
to select "Standard"
4. Press [ENTER] Confirms selection
5. Press [17] [ENTER] Selects menu item 17:
“MIDI Device Number”
6. Enter [1] Valid numbers are 0 to 15
when "Standard MIDI" is
selected from Menu Item 18
7. Press [ENTER] Confirms selection
Console Tracking
Using Standard MIDI can allow a second similar console to act as a backup
console during a show.
Procedure: Notes:
1. Make sure both consoles have the
same versions of operating software loaded
2. Set both consoles to the same MIDI
channel as explained in the procedure above
3. Connect a standard MIDI cable from
the MIDI OUT port of the Master console
to the MIDI IN port of the Slave console
To Next Page
Loading...
