User Guide Chapter 2 Displays
Rev. 1.30.03.07.r1 Page 23
Sub-Displays of Setup: Print, Disk, Macro,
Device Assignment, Profile, Real Time Event,
Network
These sub-displays are accessed from the Setup display. References are
given below to relevant chapters for display examples and operational
information.
Print Sub-Display
This display is accessed by pressing (Print) while in the Setup display.
There are many different print options available including printing out
detailed lists of cues, submasters, groups, macros, effects, devices, real-
time events and patching assignments. See
Chapter 13 Printing
for more
information.
Disk Sub-Display
Pressing (Disk) will bring up the Disk Menu from which you can save, load,
delete or rename show files. Floppy disk formatting and loading console
system software is performed here also. See
Chapter 11 Memory Functions
.
Macro Sub-Display
A Macro is a recorded sequence of keystrokes meant to serve as a time
saving technique for executing a repeated series of commands. Macros are
recorded, configured and edited in this sub-display, which is available under
the (Macro) soft-key. See
Chapter 8 Macros
for more information and
procedures.
Device Assignment Sub-Display
Automated devices are configured and assigned in this display. Device
address start positions as well as selection of one of the available three
DMX outputs is selected here also. The Device sub-display is available under
the (Device) soft-key of the Setup display. Refer to
Chapter 10 Automated
Devices
for details on the use of this display.
To Next Page
Loading...
