Leviton 600 - Inserting and Renumbering Cues; Inserting Cues; Renumbering Cues

Chapter 5 Cues
Page 72 Rev. 1.30.03.07.r1
Inserting and Renumbering Cues
Inserting Cues
A new cue can be inserted between two existing cues. For example, to
insert a new cue between cues 1 and 2, just record the new cue as cue 1.5.
Please see the
Cue Numbering section earlier in this chapter for more
information on numbering cues.
Renumbering Cues
To renumber a cue use the (Renum) softkey. Please see the following
examples:
To renumber cue 1 to cue 5 while in the Cuesheet display:
Procedure: Notes:
1. Select Cue 1
2. Press (Renum) [5]
3. Press [ENTER]
To renumber a cue while in the Preview display:
Procedure: Notes:
1. (More) (Renum) [#]
2. Press [ENTER]
If a cue already exists with the same number as the desired
renumbered cue, a warning will appear. Pressing [ENTER] will
overwrite the existing cue.