User Guide Chapter 4 Submasters
Rev. 1.30.03.07.r1 Page 43
Submaster Playback
Submasters can be played back by either raising the submaster fader or
pressing the submaster’s bump button. It is important to note that there
are certain conditions which apply to both methods and these are explained
below.
Submaster Fader Playback
As a submaster is a number of channels recorded at certain levels, playing
back the sub at 100% (FL) will bring these channel levels to their full
recorded state. The channels are recorded proportionally, so if the sub is
played back at 50% for example, then the channels will be at 50% of their
recorded levels.
Submaster Bump Button Playback
The bump button’s function depends on its mode and if the sub is recorded
as a Timed Submaster (please see following
Timed Submasters
section).
Bump Button Modes: There are two types of submaster bump button
modes; Normal and Toggle.
In Normal mode the bump buttons act as momentary switches; pressing a
bump button will bring its recorded level to full, releasing it will return to
the current level of the sub fader (zero or otherwise).
In Toggle mode the bump buttons act as on/off switches; each press will
turn the submaster on or off.
Changes to the bump button mode are done in the Submaster sub-display
of Preview. To change a bump button’s mode follow below:
Procedure: Notes:
1. Press [PREVIEW] Opens the Preview display
2. Press (SelSub) [#]
3. Press (More) to change Press 2 times until (Toggle)
soft-key levels appears.
4. Press (Toggle) to activate or "Tog" appears below "Dwl" in
deactivate Toggle mode attributes line
To Next Page
Loading...
