Chapter 9 Patching
Page 146 Rev. 1.30.03.07.r1
Compressed Mode vs. Expanded Mode
The default mode when viewing or creating a profile is called Compressed
Mode and shows the profile divided into 16 equal sections. Expanded Mode
allows you to view or create a profile in more detail and is divided up into
255 equal sections.
To switch to Expanded mode press the [ENTER] key while in Compressed
mode. To switch back to Compressed mode, press the [ENTER] key again.
Creating and Assigning Custom Profiles
Follow the example steps below to create a custom profile:
Procedure: Notes:
1. Press [SETUP]
2. Press (Profil) soft-key
3. Press [PROFILE] on keypad
4. Enter [#] for new profile number
5. Press [ENTER]
6. Use the left/right arrow keys to move
channel level to desired column
7. Use the up/down arrow keys to move
dimmer output to desired level
Follow the steps below to assign a custom profile to a dimmer:
Procedure: Notes:
1. Press [PATCH]
2. Press [DIMMER] [1] Selects Dimmer for Profile
to be assigned to.
3. Press [PROFILE] [1] Command line reads:
Dimmer 1 Profile 1
4. Press [ENTER]
To Next Page
Loading...
