Chapter 10 Automated Devices
Page 158 Rev. 1.30.03.07.r1
The following table gives descriptions of the Device display soft-keys:
Table 10.2 Device Display Soft-keys
It may sometimes be desirable to disable the trackball while making
encoder wheel adjustments. This will prevent the trackball from
accidentally being moved very slightly which may affect the final
record. To disable the trackball, press (NoTrkb) in the Device display.
To re-enable the trackball, press (Trkbal).
Soft-key Description
(Q Mode) Switches Cue Record Modes, see
Chapter 5 Cues
for more
information.
(KillDv) Quickly closes the shutter of devices which are active on
stage. For example, press (KillDv) [#] [ENTER].
(SelAll) Selects all device traits of assigned devices for record.
Trait names will appear in white.
(RelAll) De-selects all device traits of assigned devices so they will
not be recorded. Trait names will appear in gray.
(SelP&T) Selects only pan and tilt traits of assigned devices for
record. The pan and tilt trait names will appear in white.
(RelP&T) De-selects only pan and tilt traits of assigned devices so
they will not be recorded. The pan and tilt trait names will
appear in gray.
(NoTrkb) /
(Trkbal)
Disables trackball / Enables trackball. See note below.
(Monitr) Switches active monitors if using secondary video option.
To Next Page
Loading...
