Leviton 600 - Page 72

Chapter 5 Cues
Page 60 Rev. 1.30.03.07.r1
Recording a Cue with a Single Fade Time
Follow the example steps below to record a cue with a single fade time:
Procedure: Notes:
1. Press [STAGE]
2. Press [ENTER] [AT] [ENTER] [CLEAR]
to clear screen (if necessary)
3. Press [50] [AND] [61] Selects channels to be
recorded
4. Press [FULL] Not necessary to press the
[AT] key when recording Full
5. Press [RECORD CUE] [3]
6. Press [TIME] [5] Adds single up/down fade
time of 5 seconds
7. Press [ENTER] Records cue 3
Recording a Cue with Split Fade Times
The [AND] hard-key is used to assign separate up and down times. In the
command line, the up time and down times are shown separated by a "+".
Follow the steps below to record a cue in Stage with split fade times:
Procedure: Notes:
1. Press [STAGE]
2. Press [ENTER] [AT] [ENTER] [CLEAR]
to clear screen (if necessary)
3. Press [50] [AND] [61] Selects channels to be
recorded
4. Press [FULL] Not necessary to press the
[AT] key when recording Full
5. Press [RECORD CUE] [5]
6. Press [TIME] [5] [AND] [7] Adds split up/down fade times
of 5 and 7 seconds
7. Press [ENTER] Records cue 5
The up time specifies how long it takes for the next cue to fade in. The
down time specifies how long it takes for the previous cue to fade out.