2-68 Service Manual
5026
8
Place a voltmeter between Fuser DC
autoconnect pin 8 and ground (pin 6).
Does the meter read +5 V dc?
Go to step 9. Replace the fuser DC
cable. See “Fuser DC
cable removal” on
page 4-121.
9
1. Replace the fuser. See “Fuser removal”
on page 4-118.
2. Bring the printer up in Diagnostics Menu
(turn off the printer, press and hold
buttons 3 and 6, then turn on the printer).
3. Navigate to SENSOR TESTS > Dynamic
Sensors > Fuser Exit.
4. Open the front access door and the top
access cover.
Did the fuser exit sensor change from Open to
Closed?
Problem resolved Replace the system board.
See “System board
removal” on page 4-163.
Step Questions / actions Yes No
To Next Page
Loading...
Need help?
General
