3-4 Service Manual
5026
Servo Laser Test See “Servo Laser Test” on page 3-20.
DEVICE TESTS (if hard disk or flash is installed)
Quick Disk Test See “Quick Disk Test” on page 3-21.
Disk Test/Clean See “Disk Test/Clean” on page 3-22.
Flash Test See “Flash Test” on page 3-22.
PRINTER SETUP
Defaults See “Defaults” on page 3-22.
Prt Color Pg Count See “Page Counts” on page 3-23.
Prt Mono Pg Count
Perm Page Count
Serial Number See “Serial Number” on page 3-23.
Model Name See “Model Name” on page 3-23.
Engine Setting 1 through 4 See “Engine Setting 1 through 4” on page 3-23.
Configuration ID See “Configuration ID” on page 3-23.
Reset Color Cal See “Reset color calibration (Reset Color Cal)” on page 3-24.
Par 1 Strobe Adj See “Parallel 1 strobe adjustment (Par 1 Strobe Adj)” on
page 3-24.
Motor Calibration See “Motor Calibration” on page 3-24.
EP SETUP
EP Defaults See “EP Defaults” on page 3-24.
Fuser Temp See “Fuser temperature (Fuser Temp)” on page 3-24.
DC Charge Adjust See “DC Charge Adjust, Dev Bias Adj, Transfer Adjust” on
page 3-25.
Dev Bias Adj
Transfer Adjust
REPORTS
Menu Settings Page See “Menu Settings Page” on page 3-25.
EVENT LOG
Display Log See “Display Log” on page 3-25.
Print Log See “Print Log” on page 3-26.
Clear Log See “Clear Log” on page 3-26.
EXIT DIAGNOSTICS This selection exits Diagnostics mode, and Resetting the Printer
displays. The printer performs a POR, and returns to normal mode.
To Next Page
Loading...
