IPECS Release 5
Feature Description & Operation 5.0
2-3
To terminate an Alarm Signal while idle:
1. Dial the Flex Numbering Plan code 565, confirmation tone is received and the Alarm Signal is
terminated. If the alarm condition is cleared, the system will automatically rearm the alarm
monitoring.
Or,
1. Press the {
ALARM STOP} button.
Conditions
1. The Alarm contacts must be “dry”, no voltage or current source connected.
2. Only an iPECS Phone may be assigned to receive Alarm/Door Bell signals.
3. An iPECS Phone with LCD assigned to receive Alarm/Door Bell signals will show “ALARM” or
“DOOR BELL” as appropriate.
Programming
SYSTEM 1. Alarm Enable (PGM 163-Btn 1)
2. Alarm Contact Type (PGM 163-Btn 2)
3. Alarm/Doorbell Mode (PGM 163-Btn 3)
4. Alarm Signal Mode (PGM 163-Btn 4)
S
TATION 1. Alarm/Door Bell Attribute (PGM 113-Btn 8)
Related Features
Door Open
Hardware
iPECS Phone
External contact connected to Alarm input of MFIM, refer to iPECS
Hardware Description &
Installation Manual.
2.3 AUTHORIZATION CODES (PASSWORD)
Description
Authorization Codes provide a means to control access to Off Premise Call Forward, Walking COS,
or DISA and may be required for outgoing CO/IP Line or LCR access based on configuration of the
iPECS database. When users dial an Authorization Code that matches an Authorization Code
stored in the database, the system invokes the Station COS or the COS assigned to Authorization
code. Each Authorization code has separate Day/Night mode COS assignments.
There are two types of Authorization Codes, Station and System. A Station Authorization Code is
specifically related to a given station and intended for a single user. The System Authorization
Codes are intended for use by any station in the system.
To Next Page
Loading...
