LG IPECS - Page 209

IPECS Release 5
Feature Description & Operation 5.0
3-13
When a Message is waiting, the [
MSG/CALLBK] button LED of iPECS Phones and digital phones
flashes and, for properly equipped SLTs, the MW Lamp will flash.
Operation
iPECS Phone
To leave a Message Wait, while receiving ring back tone or no response on a call announce (H or
P mode)
1. Press the [
MSG/CALLBK] button, confirmation tone received.
2. Hang up, Message Wait activated.
To leave a Message Wait, while receiving DND tone
1. Press the [
MSG/CALLBK] button, confirmation tone received.
2. Hang-up, Message Wait activated.
To leave a Call Back (queue for a station), while receiving busy
1. Press the [
MSG/CALLBK] button, the user receives confirmation tone.
2. Hang up, return to idle.
To respond to a Call back recall, when the busy station is available the system calls back,
1. Lift the handset or press the [
SPEAKER] button.
2. Previously busy station is called.
To retrieve Station Messages Waiting
1. Press [
MSG/CALLBK] button.
Either the message contents summary will be shown as below or the Station Messages Waiting
will be listed, see step 3 below.
ST CL VS VM FS MS
001 001 005 006 001 004
2. Dial ‘1’ to select ST (Station Message Wait)
‘1’
Î ST: Station Message Wait,
‘2’
Î CL: CLI Message Wait
‘3’
Î VS: VMIM/VSF Message Wait
‘4’
Î VM: commercial Voice Mail
‘5’
Î FS: Feature server
‘6’
Î MS: SMS message wait.
3. Press the [
VOL UP]/[VOL DOWN] button to scroll through the Station Messages
To return a call for the current Station Message
1. Press the [
SAVE] button.
To delete the first Message Wait from the list