Lucent Technologies DDM-2000 OC-12 - Page 17

List of Figures
363-206-208
Issue 5 November 2000 [YLL
Lucent Technologies - Proprietary
See Notice on first page
Figure 3-20. Single Shelf DS1 Sync Timing, TL1/X.25 Interface,
Order Wire, and Modem Cabling 3-65
Figure 3-21. DS1 Sync Timing, TL1/X.25 Interface, Order Wire, and
Modem Cabling 3-66
Figure 3-22. DS1 Sync Timing, TL1/X.25 Interface, Order Wire, and
Modem Cabling for DDM-2000 OC-3/OC-12 Combined Bay 3-67
4 DDM-2000 OC-3/OC-12 Bay Installation
Figure 4-1. ED8C906-300 Groups 4 and 6 OC-3/OC-12 Bays 4-11
Figure 4-2. OC3/OC12 Bay Installation 4-12
Figure 4-3. Junction at Bottom of Adjacent Bays 4-13
Figure 4-4. DDM-2000 OC3/OC12 Bay Fuse Panel 4-14
5 Powering, Verification, and Circuit Pack Installation for the
DDM-2000 OC-12 Multiplexer
Figure 5-1. BBG5 SYSCTL Option Setting Guidelines 5-15
Figure 5-2. Power Cabling 5-16
Figure 5-3. BBG5 SYSCTL Option Switches (Sheet 1 of 4) 5-17
Figure 5-4. BBG8 SYSCTL Option Switches (Sheet 1 of 2) 5-21
Figure 5-5. BCP1 OHCTL Option Switches (Sheet 1 of 2) 5-23
Figure 5-6. BBG11/BBG11B 3DS3 Option Jumpers 5-25
Figure 5-7. BBG12 3STS1E Option Jumpers 5-26
Figure 5-8. BBF2B/BBF4 TGS Option Switches for OC-12 Multiplexer
(Sheet 1 of 2) 5-27
6 Stand-Alone (Local) Installation Tests for the DDM-2000 OC-12
Multiplexer
Figure 6-1. DDM-2000 OC-12 User Panel 6-33
Figure 6-2. Lightguide Buildout Assembly Change Procedure 6-34