Issue 5 November 2000
363-206-208
Powering, Verification, and Circuit Pack Installation for the DDM-2000 OC-12 Multiplexer
Lucent Technologies - Proprietary
See Notice on first page
Press the “Escape/Esc” key to activate the new baud rate and
return to CTRM.
(8) The following steps are for downloading Release 7:
a. Enter the "term" command. Observe the message that is printed. The
message gives the user the choice to continue or not continue with the
download procedure. Disregard the message:
Can’t find script <init>
b. A brief messages appears next and will ask you to:
Press any key to continue
c. Within 2 minutes, you will see the following
Interface ready. (Type Alt-h for help.)
Communications established
Searching for optimal transfer rate.
Handshake established at <baudrate> baud.
In Progress .....
NOTE:
A series of dots following the ‘In Progress’ message will continue while the soft-
ware is downloaded. A prompt will be displayed when the next diskette is
required.
(9) After completion of the Release 5 or Release 11 downloading, the following
message will appear:
ins-prog: TID COMPLD
(10)An AGNE alarm will exist upon completion of the download. To extinguish this
alarm, set the AGNE to yes by using the set-ne command.
NOTE:
The AGNE is not supported in OC-12, Release 7.
(11)Repeat the download procedure for all spare BBG8 SYSCTL and BCP4 OHCTL
circuit packs.
To Next Page
Loading...
Need help?
General
