MASSO
MASSO Documentation
Setting up soft limits is important to prevent your machine from crashing due to gcode command that
might result in motion outside your machines physical limits.
Set up incorrectly it will restrict machine travel and in extreme cases prevent the machine from
moving at all.
Minimum and maximum travel setup instructions
Additional resource video
Scan the QR code to watch the MASSO video tutorial on YouTube
Or, Click here to view the video
Auto Tool Zero
This feature is used to automatically calculate and adjust the length of each tool. MASSO takes a
measurement when you home your machine and will return to the touch off point when a tool change is
requested.
Please note that the thickness of the auto tool zero touch off is irrelevant as it is a reference point only. It
uses the difference between where you zero your cutter and the initial measurement it took when homing to
determine the length of each tool when making a tool change.
CAUTION: Never change a tool after you have homed your machine unless instructed to do so by
MASSO. If you must change a tool without MASSO requesting it then do it before homing or home
your machine immediately after to get a new reference. Otherwise your next tool change and all
the ones that follow will be wrong.
Automatic tool length setup instructions
Additional resource video
v5.18 - 08 Apr,2021
www.masso.com.au Page 159 of 477
To Next Page
Loading...
