MASSO
MASSO Documentation
A special output signal "ES" (E-Stop output) is available on the outputs terminal. This output is internally
hardwired to the E-Stop button signals and goes LOW when the E-Stop button is pressed.
CAUTION: This output must be used to control a relay and then the relay must be able to disable
all drives and actuators on the machine. The user should not rely on the software to stop the axis,
spindle or other actuators in case of an emergency and must disable all drives electrically.
Here is a great video from CNCnutz explaining the entire process
Scan the QR code to watch the MASSO video tutorial on YouTube
Or, Click here to view the video
v5.18 - 08 Apr,2021
www.masso.com.au Page 275 of 477
To Next Page
Loading...
