MASSO
MASSO Documentation
press the space-bar key on the keyboard. These settings are automatically saved.
INFORMATION: Touch probe to skip is available on MASSO G3 software version 3.47 and above.
When using a touch probe, if auto tool zero is enabled, the controller will try to automatically do an auto tool
zero which can damage the touch probe. If a tool number is entered in the above settings then MASSO will
automatically skip auto tool zero for this tool number and the user can enter the calibrated length of the touch
probe in the F4-Tools & Work Offset screen.
This also disables the spindle so that it cannot be accidentally turned on when the touch probe is loaded.
v5.18 - 08 Apr,2021
www.masso.com.au Page 392 of 477
To Next Page
Loading...
