Navigating the mix buses 65
PRO Series Live Audio Systems
Owner’s Manual
>> To navigate a mix bus to the control surface
Do one of the following:
• Scroll to the desired mix bus using the scroll by 1 buttons in the mix section. Mix
bus selection follows the scrolling.
• Scroll the desired bank of mix buses to the control surface using the scroll by 8
buttons in the mix section.
>> To select a mix bus
Do one of the following:
• Scroll buttons Scroll to the desired mix bus using the scroll by 1 buttons in the
mix section. Mix bus selection follows the scrolling.
• Touch sensitive control knobs With the desired mix bus assigned to the mix
section on the control surface, touch/operate its control knob.
>> To navigate the mix bus processing area to the channel strip
Press the quick access button in the mix section of the desired input fast strip. This
does not affect the current population of the output fast zone.
You can select an aux bus or matrix bus processing area on the GUI by clicking on the
title of the desired bank of mix buses in the input channel overview of the GUI
channel strip (see Figure 17, “Typical sends sections of the mixes in the GUI channel
strip,” on page 106).
5 Display Shows the number of the currently selected mix bus
and its type.
6 FLIP button See “Controlling the mix buses in flip mode” on
page 48.
Item Element(s) Description
To Next Page
Loading...
Need help?
General
