Midas PRO SERIES

602 Appendix P: Parameters Copied Through Scenes
PRO Series Live Audio Systems
Owner’s Manual
Comp./Output Dyn
The following diagram shows the parameters of the compressor processing area copied
through scenes.
Note: Only the corrective compressor is shown above, but this is typically the same for
the other compressor modes (adaptive, creative, vintage and shimmer).
11 delay control knob Delay level
12 C/O switch
Order of processing: Dyn.
JIns.JEQ or
EQ
JIns.JDyn.
13 Graphic Order of processing
14 Field Direct input source
Item Control Parameter
1 DYN/[CMP] switch Compressor on/off
2 release control knob Compressor release
3 threshold control
knob
Compressor threshold
4 KNEE pushbutton Compressor knee: hard, medium or soft
5 IN switch Compressor sidechain in/out
6 freq control knob Compressor sidechain frequency
7 WIDTH pushbutton Compressor sidechain width: 2 Oct, 1 Oct or
0.3 Oct
Item Control Parameter
Compressor
processing area in
GUI channel strip
3
11
6
7
2
10
9
8
10
9
8
4
3
11
2
5
6
7
1
3
aux send
overview in GUI
channel strip
5
4
1