Saving scope parameters in a scene 219
PRO Series Live Audio Systems
Owner’s Manual
Saving scope parameters in a scene
Scope parameters have to be saved in a scene.
>> To save your selected parameters in a scene
1 Save the parameters you want into a scene (see “To create a new scene using the
current settings” on page 115).
2 Select the desired recall scope parameters (see “Selecting scope parameter
sections” on page 215).
3 Overwrite the scene by clicking the “Overwrite scene” option (see “To create a
new scene using the current settings” on page 115).
Using store scope
Caution!
Although store scope is sometimes useful in very specific
situations, it must always be used with care. This is because it is
possible that control settings will not be stored at all and will
consequently be lost. Therefore, it is much safer to use recall store
and aways store everything.
Please use store scope with great care and observe the Caution above. All of the
methods of the recall scope operation, as detailed in this chapter, apply equally to store
scope.
To Next Page
Loading...
Need help?
General
