421
PRO Series Live Audio Systems
Owner’s Manual
Appendix K: Parameters Affected By
Scope
This appendix shows the parameters affected by scope.
Note: The parameter areas for the scopes (recall and store) and the safes are basically
the same. However, the way they are presented in this manual in their respective
appendices is different. This may provide you with a useful alternative when referring
to this material, should you prefer one more than the other (see
Appendix M "Parameters Protected By Safes" on page 469).
Introduction
This appendix shows you which parameters are or are not scoped when you select the
parameter sections in the channels, buses, groups, effects and GEQs on the Recall
Scope and Store Scope screens.
There is a section for each area (channel, bus, group, effect and GEQ) on each scope
screen, and these sections are then subdivided according to the processing areas in the
fast/channel strips on the control surface and GUI.
The following diagram shows typical examples of PRO Series Recall Scope and Store
Scope screens (with no parameter sections selected), and the table to the right shows
what the symbols in each section mean. In the table the orange letters in the Ref.
column are used in the tables throughout this appendix to help you quickly identify the
parameter sections.
Ref.
Parameter
section Symbol
A Routing
B All
C Mic Amp
D EQ
E Dyn
F Busses
G Mute
H Fader
To Next Page
Loading...
Need help?
General
